Hitachi Vantara HQT-4420 Certification Exam Sample Questions and Answers

Before you write the Hitachi Vantara Content Platform Installation (HQT-4420) certification exam, you may have certain doubts in your mind regarding the pattern of the test, the types of questions asked in it, the difficulty level of the questions and time required to complete the questions. These Hitachi Vantara Qualified Professional - Hitachi Content Platform Installation sample questions and demo exam help you in removing these doubts and prepare you to take the test.

The best approach to pass your Hitachi Vantara HQT-4420 exam is to challenge and improve your knowledge. To test your learning and identify improvement areas with actual exam format, we suggest you practice with Premium Hitachi Vantara HQT-4420 Certification Practice Exam. The practice test is one of the most important elements of your Hitachi Vantara Content Platform Installation Professional exam study strategy to discover your strengths and weaknesses, to improve your time management skills and to get an idea of the score you can expect.

Hitachi Vantara HQT-4420 (Content Platform Installation) Sample Questions:

01. An installer is filling in the IP plan for an S Series node management network and intends to run it dual-stack. The site's numbering convention would give server module 1 the fourth octet 10 in IPv4 and the last segment 000A in IPv6.

What does the documentation say about those two values?

a) Only the IPv4 value is withheld; no equivalent restriction is written for an IPv6 gateway or server module address

b) Both are reserved for authorized service providers, so neither may be assigned to a server module

c) Neither is restricted; those two values sit outside the documented default range for this network

d) Both are usable on a server module but not on the gateway address, which the documentation numbers 254 by default

02. You are carrying out the documented upgrade from HCP with internal storage to HCP with SAN-attached storage, and both replication links are in place.

When do you fail over the link, and what may have to happen first?

a) After the internal storage systems have been decommissioned

b) As soon as the second link is created, with the chain keeping both systems in step from then on

c) Once your service provider has finalized a data migration off the internal storage nodes

d) Once replication is completely up to date, after stopping clients from writing to the internal storage system if that proves necessary

03. Shortly after an installation, the Hardware page raises No IPMI status available for chassis fans for a CB 320 server chassis.

What does the documentation have you check before escalating?

a) That the node's front-end interfaces are all active in their bond

b) That the CB 320 server chassis configuration names the right storage node and is otherwise correct

c) That the management network cables on each chassis are seated correctly

d) That the chassis fans are turning, with the inlet temperature in range

04. The forward lookup zone for an S Series node holds a wildcard host entry pointing at the server modules' virtual addresses on the access network, plus one specific host entry, admin, pointing at their management network addresses.

Which entry serves each of the node's interfaces?

a) The Management Console uses the admin entry, and the management API and the S3 compatible API fall back to the wildcard

b) The wildcard entry serves every interface, because a wildcard takes precedence over specific host entries in the same zone

c) The Management Console and the management API both resolve through the admin entry, and only the S3 compatible API uses the wildcard

d) The admin entry serves every interface, because a specific host entry replaces the wildcard for the whole zone

05. On an HCP with internal storage system, an administrator raises the ingest tier DPL on the system's default service plan from two to three. A new service plan is created afterwards.

What ingest tier DPL does the new plan start from?

a) Three, because the system-wide default follows whatever the default service plan currently uses.

b) Two, because the two settings are independent of each other.

c) Three, because the default service plan supplies the starting values for every plan created after it.

d) One, because a new plan starts from the lowest ingest tier DPL the system permits.

06. Two alerts are in effect for one S Series enclosure, and the Management Console shows a single orange icon in the corner of the enclosure's box. What can you conclude?

a) The most severe of the two alerts is a warning

b) Both alerts are warnings, with the Console displaying one icon for each severity in effect

c) An error condition is present and has already been acknowledged

d) Both alerts are informational only and call for no action

07. A site is completing the DNS section of the installation information for a new HCP system. It runs several DNS servers and asks the installation professional which of them belong in the upstream list and which in the downstream list.

How does the documentation distinguish the two?

a) Upstream refers to IPv6 resolution and downstream to IPv4, so both are needed in Dual mode.

b) The downstream and upstream roles must be filled by different servers.

c) Downstream servers route client requests to HCP; upstream ones resolve HCP's outbound traffic.

d) Upstream servers route client requests to HCP, and downstream servers resolve the traffic HCP itself initiates.

08. Maintenance on the HCP power sources means the whole system has to be shut down for an afternoon. Which statement does the documentation make about the period while HCP is shut down or restarting?

a) The Migration service carries on, leaving a retirement in progress unaffected

b) Clients keep read access to data held on S Series nodes attached to the system

c) Nodes that are shut down drop off the list on the Hardware page

d) The System Management Console is unavailable for the duration

09. You are planning a diagnostic collection from an S Series node and need to know how far back you can reach. Which two statements does the documentation make about the node's internal logs?

(Choose two.)

a) The retention period is fixed and does not vary with the space available on the node

b) The download is a single action that produces the file immediately

c) They are generally kept on the node for at least 120 days

d) A start date more than 120 days in the past cannot be selected

10. During HCP Setup you answered that the external storage arrays are shared with other applications. The customer asks whether the resulting limit on how many nodes are worked on at once can be raised after the installation.

What does the documentation say?

a) The limit is raised automatically once HCP Setup detects that the other applications have stopped using the arrays

b) The System Management Console exposes both values on the Storage page after installation

c) The limit is fixed by the answer given at installation and can only be changed by reinstalling the HCP software

d) The max_simul_nodes and max_simul_mkfs values in cluster.cfg can be changed, but not without instructions from HCP Support

Solutions:

Question: 01

Answer: b

Question: 02

Answer: d

Question: 03

Answer: b

Question: 04

Answer: a

Question: 05

Answer: b

Question: 06

Answer: a

Question: 07

Answer: c

Question: 08

Answer: d

Question: 09

Answer: c, d

Question: 10

Answer: d

Note: If you find any error in these Hitachi Vantara Content Platform Installation Professional sample questions, you can update us by write an email on feedback@nwexam.com.

Hitachi Vantara HQT-4420 Certification Exam Sample Questions and Answers

Hitachi Vantara HQT-4420 (Content Platform Installation) Sample Questions:

Solutions:

Blogs